Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
mgs1_faq [2019/11/24 22:50] – PAL Card plywood | mgs1_faq [2019/11/24 22:51] – plywood | ||
---|---|---|---|
Line 49: | Line 49: | ||
**Q: How does freezing/ | **Q: How does freezing/ | ||
- | **A:** It takes one minute and one second (1:01) to freeze or heat the card on NTSC. If you open up your menus, this **will delay the process,** so don't menu until the time has passed! Lag will delay the card timing, so it is slower | + | **A:** It takes one minute and one second (1:01) to freeze or heat the card on NTSC. If you open up your menus, this **will delay the process,** so don't menu until the time has passed! Lag will delay the card timing, so it is slower |
**Q: Do I need to enter the pipe room/steam room to heat the card?** | **Q: Do I need to enter the pipe room/steam room to heat the card?** |